![]() Once you find it you'll need to pull it out and you'll notice it already has a ring terminal installed. Locate the red wire taped between the fender well and the power junction box on the passenger side.All that's left after this is to tuck the excess wiring back up under the dash to keep it from getting in the way of your feet while driving. Plugging wiring harness into brake controller.įinally, you can mount the brake controller into the bracket you just installed. Once you have the bracket mounted, you can plug the wiring harness into the back of the controller. Bracket being mounted using existing dash panel trim screw. Just be sure wherever you decide to install them you have enough room in your wires to allow you to do so. Where you install the bracket is completely up to you, there have been brackets installed anywhere from halfway up the dash by the radio to down under on the kick panels. Step 2 – Install trailer brake controller bracket ![]() Once you have finished making the connections, it's recommended wrapping them in black electrical tape to both help keep the connections tight and secure and also to help tidy them up. To make the connections you can use butt connectors and then crimp the wires in place or you can solder them together if you wish. Remember, the factory harness colors most likely won't be the same as the wire colors on your controller so you'll need to obtain the schematic for them. Make sure you have enough wire to be able to reach to wherever you plan to mount the controller at. Once you have the trailer brake wiring to your trailer brake controller wiring mapped out, you can start making the connections. The wiring color code for the factory harness is: This is the trailer brake harness that you'll need to pull down.įigure 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |